Cleaning steps

• Rinse goggle exterior and lens under lukewarm water to remove dirt.

• Use a mild soap and water if needed; avoid solvents or harsh detergents.

• Gently wipe the lens with a clean microfiber cloth. Do not rub on coatings.

• Rinse off soap residue with clean water.

• Shake/air-dry away from direct heat, then pat dry with microfiber.

• Dry foam seals and straps separately; do not soak foam.

Lenses and coatings

• Do not wipe the inner surface with cloths; use brand-approved anti-fog sprays if foggy.

• Avoid ammonia, alcohol, or acetone on lenses.

• If you have anti-fog inserts or tear-off systems, handle per the brand’s guidance.

Frames, seals, and venting

• Clean foam seals with mild soap and water; rinse well.

• Dry straps completely before storing to prevent mold.

• Check for cracks or wear; replace if needed.

Storage

• Store in a soft or hard case to prevent scratches and exposure to sunlight.

Troubleshooting

• Fogging: reapply anti-fog product; improve airflow/venting; ensure proper fit.

• Scratches: replace lens.

• Loose strap: adjust or replace strap.

nose cover removal and refit

• From inside the goggles, locate the two clips behind the nose bridge.

• Push the two clips inward to release the nose piece from the frame.

• At the same time, pull the nose piece downward to remove it.

• Align the nose piece with the frame.

• Push the nose piece up and snap the two clips back into place.

• Ensure it’s securely seated and flush with the frame.